Sectional Point Repair in Lordstown

Farm lots, ranches, and former septic systems

Lordstown is best known for the auto plant and the industrial corridor along the Ohio Turnpike, but most of the village is still farmland and large residential lots along Route 45, Salt Springs Road, Hallock Young Road, and the other county roads. The housing ranges from farmhouses built before 1920 to ranches and split-levels from the 1960s and 1970s, with newer homes scattered among them. Many of these properties were on septic systems until sanitary sewers were extended, and the laterals reflect that history: clay or cast iron from the house to where the old tank sat, then whatever the plumber used to reach the new main, often PVC.

The long runs are the notable thing here. A lateral from a farmhouse set back from the road may run well over a hundred feet, and a camera inspection with a locator is the only way to know its route and materials.

Wet till, settlement, and roots at the tie-in

The soil in Lordstown is glacial till with heavy clay, flat and slow to drain, and the water table rises close to the surface in spring across much of the village. Trenches backfilled with that till settle unevenly, and a long PVC lateral laid in it develops bellies where water stands and solids settle. Frost reaches roughly three feet and heaves the run nearest the house every winter, which opens clay joints and can rock a transition coupling loose where old pipe meets new.

The trees on these lots are big. Silver maples, willows, and sycamores in the wet ground, and the oaks and maples planted around farmhouses a century ago, send roots to any weeping joint. The most common root problem in Lordstown is at the transition from the old house line to the newer sewer connection, or at the stub where the septic line was supposed to be capped. Sanitary sewers here are separate from storm drainage, so a backup is almost always the lateral itself.

Lining, point repair, or bursting on a long lateral

For an older clay or cast-iron section with roots and cracks, cured-in-place lining is the fix. After a camera inspection and hydro jetting, the installer inverts an epoxy-saturated felt liner from a cleanout and cures it with hot water, steam, or UV. A single liner can run the full length, and it will pass through the transition between materials as long as the pipe stays round and the diameter does not change abruptly. For one separated joint or a cracked transition coupling in an otherwise sound line, a sectional point repair is the better value.

Pipe bursting is the method when a belly holds standing water, when a section has collapsed, or when the old house line is too small for a home that has added bathrooms. The bursting head is pulled from a pit near the main to a pit at the house while fused HDPE follows, and on a long Lordstown run the installer may add an intermediate pit. Any abandoned septic branch should be cut off and capped during the work.

Village and county permits

Lateral work in Lordstown may be permitted by the village or by the Trumbull County Sanitary Engineer, depending on who owns the main serving your road. Either office will review the post-cure video for a liner or inspect the connection before backfill for a bursting job, and either will want to know that no downspouts, sump pumps, or footer drains are tied into the sanitary lateral. Opening a county or state road requires a separate right-of-way permit from the agency that maintains it.

In most communities the owner's responsibility runs to the main. Confirm which office covers your address and ask the installer to handle the permit and the inspection appointment.

What to expect and how to choose an installer

A point repair is a few hours. A full liner on a long run can take a full day, with jetting, filming, wet-out, a cure of a few hours, reinstatement of branches, and a final video. A bursting crew brings an excavator for the pits, a pulling rig, and a pump for groundwater, and returns the next day to restore the lawn or field.

Each bid should name the method, the measured footage, the liner thickness or HDPE size, the pit locations if any, and what happens if the camera finds a different material than expected. To compare installers whose training and insurance have been verified, find a verified CIPP contractor and ask for a reference from a long rural lateral in Lordstown or a neighboring township. A crew that has lined through a septic-conversion transition will know what to look for at the tie-in.

Sectional Point Repair in Lordstown

Fix the spot, not the line

A sectional point repair treats a short length of pipe, usually two to six feet, instead of the whole lateral. A short fiberglass or felt liner saturated with resin is positioned over the defect on an inflatable packer, pressed against the wall, and cured in place. The rest of the line is untouched. Where the defect cannot be lined, the alternative is a small excavation at that exact spot, made possible because the camera and locator have already marked it to within inches.

When it makes sense

One identifiable defect, or two or three close together, on a line whose remaining footage is sound: a joint crushed when a driveway was poured over it, a single root-intruded joint under a parkway tree, a break where the lateral crosses another utility trench, or the transition where under-slab cast iron meets the clay or ABS running to the street.

When it does not

If the camera shows the same defect at every joint, or channeling along the whole bottom of a cast iron line, fixing one spot moves the next backup a few feet down the pipe. A full liner costs more today and far less over the next few years.

A fair test

Ask to see footage of the pipe on both sides of the proposed repair. If it is clean for the full run, a point repair is honest and economical. If it is not, ask why a full liner was not proposed.

More trenchless services in Lordstown

Questions we hear in Lordstown